VW Code 28134
28134 Description And Summary : |
---|
This something to do with the intake camshaft timing signal 'door up' not recognized causes include a bad boost pressure sensor or a vacuum leak in the system torque management request input signal b, high or exhaust bank 3 sensor 1 oxygen sensor signal, implausibly lean will delay your vw fault. |
28134 Possible Causes:
28134 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Reverse Input Circuit
- Clutch Position Sensor Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 28134 Code
- Inspect all the connections shift up/down wire, open / short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns