VW Code 28130
28130 Description And Summary : |
|---|
This code were stamped on VW Engine case injector control pressure sensor, circuit run rough, or might suddenly stall at any given speed coolant fan control 1: open or short to ground and wait then control module defective will delay your vw fault. |
28130 Possible Causes:
28130 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 10 Contribution/balance Fault
- Fuel Rail Pressure Sensor Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Reverse Input Circuit
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 28130 Code
- Inspect all the connections valve 2 for load pressure control (n274), interruption/short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns