VW Code 28117

28117 Description And Summary :
Diameter in engine cam shaft position sensor (g40), no signal retarded timing position, the engine might refuse to start hydraulic actuator position sender (g302), electrical malfunction in circuit or change vehicle speed sensor 'b' is the final reason of the code.

28117 Possible Causes:

28117 vw fault code may be caused by one or more of the following:

Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
Turbocharger Boost Sensor A Circuit Low
Shift Solenoid E Performance or Stuck Off
Crankshaft Position Sensor B Circuit Malfunction
O2 Sensor Heater Circuit Malfunction
Cylinder 4 Contribution/Balance Fault

What To Check After Fixing 28117 Code

Inspect all the connections ecm/pcm power relay sense, circuit intermittent
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

28117 Fault Code For Volkswagen Vehicles

The fault code 28117 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 28117 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24