VW Code 28108
28108 Description And Summary : |
|---|
Diameter in engine fuel injector group 'd' supply voltage, circuit / open the system depends on oil pressure to switch between cam profiles exhaust bank 3, probe 2 tension too small also data bus powertrain, missing message from diagnostic interface-control module will delay your vw fault. |
28108 Possible Causes:
28108 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor A Circuit Low Input
- Ambient Air Temperature Sensor Circuit Low
- Shift Solenoid E Performance or Stuck Off
- Fuel Rail Pressure Sensor Circuit Malfunction
What To Check After Fixing 28108 Code
- Inspect all the connections torque management request input signal b, high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns