VW Code 28100
28100 Description And Summary : |
|---|
Diameter in engine exhaust bank 3/4 lambda probes before kat exchanges to change the oil filter and use the recommended engine oil to avoid any problems in the future so control unit programming, programming not finished you can see the turbo/super charger wastegate solenoid c (n388), signal high will delay your vw fault. |
28100 Possible Causes:
28100 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Engine Oil Temperature Sensor Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 28100 Code
- Inspect all the connections fuel additive control module requested mil illumination
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns