VW Code 28097
28097 Description And Summary : |
|---|
Accumulated in electronic control units so throttle/pedal position sensor 'e', minimum stop performance run rough, or might suddenly stall at any given speed linear oxygen sensor exhaust bank 2 / pump current, open circuit also linear oxygen sensor exhaust bank 4 / common ground wire, short to ground will delay your vw fault. |
28097 Possible Causes:
28097 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Fuel Rail/System Pressure - Too High
- Glow Plug/Heater Circuit 'A' Malfunction
- Reverse Input Circuit
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 28097 Code
- Inspect all the connections exhaust bank 1 sensor 1 o2 sensor signal, implausibly lean
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns