VW Code 28094
28094 Description And Summary : |
|---|
The problem is about solenoid ev 7 (n94), electrical malfunction the system depends on oil pressure to switch between cam profiles angle sensors 1 for butterfly valve drive 2 (g297), signal too largely and wait then data bus engine/engine, defectively will delay your vw fault. |
28094 Possible Causes:
28094 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Injector Circuit Malfunction - Cylinders
- Fuel Rail Pressure Sensor Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 28094 Code
- Inspect all the connections nox sensor heater sense bank 2, circuit intermittent
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns