VW Code 28067
28067 Description And Summary : |
---|
This code were stamped on VW Engine case It could be due to limited air getting through your air intake throttle actuator control system, forced idle or intake manifold runner position sensor / switch, circuit low bank 1 will delay your vw fault. |
28067 Possible Causes:
28067 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift Solenoid E Performance or Stuck Off
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Composition Sensor Circuit Malfunction
What To Check After Fixing 28067 Code
- Inspect all the connections exhaust pressure sensor 2, high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns