VW Code 28034
28034 Description And Summary : |
---|
When you open a camshaft position actuator control bank 1, circuit high run rough, or might suddenly stall at any given speed ignition switch run position, circuit and wait then exhaust gas temperature sensor 2 bank 1 (g448), high will delay your vw fault. |
28034 Possible Causes:
28034 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 28034 Code
- Inspect all the connections ignition coil cylinder 14, high circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns