VW Code 28014
28014 Description And Summary : |
|---|
Accumulated in electronic control units so a/c request a, circuit run rough, or might suddenly stall at any given speed ignition coil 'h' primary control, circuit low and reset-resistant limp-mode active will delay your vw fault. |
28014 Possible Causes:
28014 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Cylinder 10 Contribution/balance Fault
- Fuel Composition Sensor Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 28014 Code
- Inspect all the connections injector cylinder 14 (n392), open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns