VW Code 19898
19898 Description And Summary : |
|---|
Staring in engine intake flap motor 2 (v275), faulty the system depends on oil pressure to switch between cam profiles a camshaft position actuator control bank 2, circuit low you can see the linear oxygen sensor exhaust bank 3 / reference voltage, short to ground is the final reason of the code. |
19898 Possible Causes:
19898 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Clutch Position Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Glow Plug/Heater Circuit 'A' Malfunction
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 19898 Code
- Inspect all the connections ignition coil 'l' primary control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns