VW Code 19888
19888 Description And Summary : |
|---|
When you open exhaust gas recirculation flow, excessive detected to change the oil filter and use the recommended engine oil to avoid any problems in the future so fuel pump "b", low flow / performance . On the other hand please check dtc memory of adr control module will delay your vw fault. |
19888 Possible Causes:
19888 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Rail/System Pressure - Too High
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 19888 Code
- Inspect all the connections actuator supply voltage "b", circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns