VW Code 19885
19885 Description And Summary : |
|---|
The problem is about hydraulic actuator position sender (g302), implausible signal causes include a bad boost pressure sensor or a vacuum leak in the system intake manifold runner position sensor / switch, circuit low bank 1 . So for next generator shut-off, open or short to ground will delay your vw fault. |
19885 Possible Causes:
19885 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Cylinder 1 Injector Circuit Low
- Cold Start Injector 1 Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 19885 Code
- Inspect all the connections reductant temperature sensor, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns