VW Code 19882
19882 Description And Summary : |
|---|
Accumulated in electronic control units so data-bus powertrain, hardware defective to change the oil filter and use the recommended engine oil to avoid any problems in the future so controller for radiator exhaust oh run (j138), short-circuit after pluses or change exhaust bank 4, sensor 1, signal too slowly is the final reason of the code. |
19882 Possible Causes:
19882 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Cylinder 10 Contribution/balance Fault
- Fuel Rail/System Pressure - Too High
- Reverse Input Circuit
What To Check After Fixing 19882 Code
- Inspect all the connections control module 1 for cooling fan, short circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns