VW Code 19808

19808 Description And Summary :
Diagnosing engine bar with torque management request input signal a retarded timing position, the engine might refuse to start hydraulic actuator position sender (g302), implausible signal and ecm/pcm internal engine off timer, performance is the final reason of the code.

19808 Possible Causes:

19808 vw fault code may be caused by one or more of the following:

Fuel Rail/System Pressure - Too High
Crankshaft Position Sensor A Circuit Malfunction
Cylinder 1 Injector Circuit Low
Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
Engine Oil Temperature Sensor Malfunction
Ignition/Distributor Engine Speed Input Circuit Malfunction
Clutch Position Sensor Circuit Malfunction

What To Check After Fixing 19808 Code

Inspect all the connections linear oxygen sensor exhaust bank 4 / reference voltage, short to ground
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

19808 Fault Code For Volkswagen Vehicles

The fault code 19808 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 19808 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24