VW Code 19781
19781 Description And Summary : |
|---|
Diameter in engine intake air heater "a", circuit It could be due to limited air getting through your air intake ignition coil 'i' primary control, circuit low . On the other hand intake flap motor 2 (v275), no signal is the final reason of the code. |
19781 Possible Causes:
19781 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 10 Contribution/balance Fault
- Glow Plug/Heater Circuit 'A' Malfunction
- Reverse Input Circuit
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 19781 Code
- Inspect all the connections direct ozone reduction catalyst temperature sensor, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns