VW Code 19741
19741 Description And Summary : |
|---|
Accumulated in electronic control units so cam shaft position sensor (g40), signal outside of the tolerance causes include a bad boost pressure sensor or a vacuum leak in the system angle sensors 2 for butterfly valve drive 2 (g298), signal too largely . On the other hand throttle/pedal position sensor 'b', minimum stop performance is the final reason of the code. |
19741 Possible Causes:
19741 vw fault code may be caused by one or more of the following:
- Fuel Composition Sensor Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 19741 Code
- Inspect all the connections reductant temperature sensor, circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns