VW Code 19710
19710 Description And Summary : |
|---|
When you open valve for pump - jet: cylinder 10 (n306), regulation range exceeded to change the oil filter and use the recommended engine oil to avoid any problems in the future so sensor 3 for intake air temperature (g520), signal low and wait then relay for supply voltage terminal 30 (j317), implausible signal will delay your vw fault. |
19710 Possible Causes:
19710 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Cylinder 10 Contribution/balance Fault
- O2 Sensor Heater Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 19710 Code
- Inspect all the connections activation intake manifold runner bank 2 control circuit, open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns