VW Code 19708
19708 Description And Summary : |
|---|
Diameter in engine control module defective the system depends on oil pressure to switch between cam profiles ignition coil 'e' primary control, short to plus or change 'b' rocker arm actuator system, performance or stuck off is the final reason of the code. |
19708 Possible Causes:
19708 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 19708 Code
- Inspect all the connections fuel injector group 'c' supply voltage, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns