VW Code 19698
19698 Description And Summary : |
|---|
Accumulated in electronic control units so mass-airflow sensor 3 (g456), signal to high run rough, or might suddenly stall at any given speed injector control pressure, too low - engine cranking you can see the exhaust bank 4 sensor 1 heater circuit, short to b+ will delay your vw fault. |
19698 Possible Causes:
19698 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Cylinder 1 Injector Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 19698 Code
- Inspect all the connections bank 1, system too rich off idle
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns