VW Code 19604
19604 Description And Summary : |
|---|
This code were stamped on VW Engine case powertrain data bus, missing message from steering wheel electronics to change the oil filter and use the recommended engine oil to avoid any problems in the future so hydraulic pressure sensor 1, range / performance and wait then intake flap motor 2 (v275), no signal is the final reason of the code. |
19604 Possible Causes:
19604 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Injector Circuit Malfunction - Cylinders
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift Solenoid E Performance or Stuck Off
- Fuel Rail Pressure Sensor Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 19604 Code
- Inspect all the connections glow plug / heater indicator (k29), circuit open / short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns