VW Code 19571
19571 Description And Summary : |
|---|
This code were stamped on VW Engine case hydraulic actuator position sender (g302), upper limit exceeded It could be due to limited air getting through your air intake nox sensor heater sense bank 2, circuit range / performance . So for next throttle/pedal position sensor / switch 'b' / 'c', voltage correlation will delay your vw fault. |
19571 Possible Causes:
19571 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Cylinder 1 Injector Circuit Low
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 19571 Code
- Inspect all the connections injector control pressure sensor, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns