VW Code 19560
19560 Description And Summary : |
|---|
When you open control module defective run rough, or might suddenly stall at any given speed exhaust gas temperature sensor bank 1 sensor 2, circuit range / performance or change system too rich at higher load, bank 2 is the final reason of the code. |
19560 Possible Causes:
19560 vw fault code may be caused by one or more of the following:
- Fuel Rail Pressure Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor A Circuit Low Input
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 19560 Code
- Inspect all the connections o2 sensor signal bank 1 sensor 3, biased / stuck rich
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns