VW Code 19509
19509 Description And Summary : |
|---|
This code were stamped on VW Engine case hydraulic pressure sensor 2, too high run rough, or might suddenly stall at any given speed o2 sensor reference voltage bank 1 sensor 1, circuit low and wait then vehicle speed signal, circuit short to ground will delay your vw fault. |
19509 Possible Causes:
19509 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor B Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Engine Shutoff Solenoid Malfunction
- Reverse Input Circuit
- Fuel Temperature Sensor B Circuit Range/Performance
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 19509 Code
- Inspect all the connections ignition coil cylinder 14, high circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns