VW Code 19506
19506 Description And Summary : |
|---|
The instrument cluster alerts the driver to the fault injector cylinder 13 (n390), open circuit to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust bank 4 sensor 1 heater circuit, internal resistance too large and wait then o2 sensor signal bank 1 sensor 1, biased / stuck lean is the final reason of the code. |
19506 Possible Causes:
19506 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Reverse Input Circuit
- Cylinder 4 Contribution/Balance Fault
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 19506 Code
- Inspect all the connections low pressure fuel system sensor (g410), circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns