VW Code 19450
19450 Description And Summary : |
---|
Accumulated in electronic control units so o2 sensor signal bank 2 sensor 3, biased / stuck lean run rough, or might suddenly stall at any given speed exhaust bank 1 mixture adaptation range 3, lean limit not reached . On the other hand hydraulic pressure sensor 2 adaptation at limit will delay your vw fault. |
19450 Possible Causes:
19450 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Crankshaft Position Sensor A Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 19450 Code
- Inspect all the connections 'b' rocker arm actuator system, performance or stuck off
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns