VW Code 19403
19403 Description And Summary : |
|---|
Diameter in engine change-over valve for intake manifold flap 2, performance or stuck off causes include a bad boost pressure sensor or a vacuum leak in the system brake pressure switch (f270), implausible signal or diesel particulate filter pressure sensor 'b', circuit high will delay your vw fault. |
19403 Possible Causes:
19403 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 19403 Code
- Inspect all the connections data bus engine/engine, missing message from ecu 2
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns