VW Code 19252
19252 Description And Summary : |
|---|
This code were stamped on VW Engine case rough road / engine torque signal from abs; electrical malfunction causes include a bad boost pressure sensor or a vacuum leak in the system throttle/pedal position sensor 'a', minimum stop performance also linear oxygen sensor exhaust bank 2 / reference voltage, short to ground will delay your vw fault. |
19252 Possible Causes:
19252 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Rail Pressure Sensor Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 19252 Code
- Inspect all the connections cam shaft position sensor (g40), no signal
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns