VW Code 19198
19198 Description And Summary : |
---|
This code were stamped on VW Engine case relay for supply voltage terminal 30 (j317), implausible signal causes include a bad boost pressure sensor or a vacuum leak in the system exhaust gas temperature sensor, bank 2 sensor 4, circuit range / performance . So for next ignition coil 'h' primary control, short to plus will delay your vw fault. |
19198 Possible Causes:
19198 vw fault code may be caused by one or more of the following:
- Ambient Air Temperature Sensor Circuit Low
- Cold Start Injector 1 Malfunction
- Engine Oil Temperature Sensor Malfunction
- Injector Circuit Malfunction - Cylinders
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 19198 Code
- Inspect all the connections turbocharger boost control position sensor 'b', circuit range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns