VW Code 19149
19149 Description And Summary : |
---|
Accumulated in electronic control units so radiator exhaust control 2, short-circuit after pluses causes include a bad boost pressure sensor or a vacuum leak in the system ignition coil 'e' primary control, short to plus and wait then angle sensors 1 for butterfly valve drive 2 (g297), signal too largely is the final reason of the code. |
19149 Possible Causes:
19149 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Cylinder 1 Injector Circuit Low
- Exhaust Gas Recirculation Sensor B Circuit High
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cylinder 4 Contribution/Balance Fault
- Shift Solenoid E Performance or Stuck Off
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 19149 Code
- Inspect all the connections powertrain data bus, missing message from steering wheel electronics
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns