VW Code 19148
19148 Description And Summary : |
|---|
This code were stamped on VW Engine case torque management request input signal a to change the oil filter and use the recommended engine oil to avoid any problems in the future so glow plug control module 2 (j703), electrical malfunction . So for next angle sensors 1 for butterfly valve drive 2 (g297), signal too small is the final reason of the code. |
19148 Possible Causes:
19148 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Crankshaft Position Sensor A Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 19148 Code
- Inspect all the connections change-over valve for intake manifold flap 2, performance or stuck off
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns