VW Code 19136
19136 Description And Summary : |
|---|
This code were stamped on VW Engine case reductant injection air pressure sensor 'a', circuit high the system depends on oil pressure to switch between cam profiles control module defective you can see the sensor 1 for hydraulic pressure in transmission, open or short to b+ is the final reason of the code. |
19136 Possible Causes:
19136 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Fuel Rail/System Pressure - Too High
- Crankshaft Position Sensor B Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 19136 Code
- Inspect all the connections ignition switch run position, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns