VW Code 19134
19134 Description And Summary : |
|---|
This code were stamped on VW Engine case linear oxygen sensor exhaust bank 4 / reference voltage, short to b+ It could be due to limited air getting through your air intake potentiometer 2 for egr (g466), signal too high . So for next change-over valve for intake manifold flap 2, performance or stuck off is the final reason of the code. |
19134 Possible Causes:
19134 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Crankshaft Position Sensor A Circuit Low Input
- Ignition Coil A Primary/Secondary Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 19134 Code
- Inspect all the connections exhaust bank 3 oxygen sensor before catalyst, heater circuit, regulation at lower limit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns