VW Code 19085
19085 Description And Summary : |
|---|
The problem is about angle sensors 1 for butterfly valve drive 2 (g297), signal too small run rough, or might suddenly stall at any given speed pre-catalyst exhaust bank 4 effect too small or change ignition coil 'c' primary control, short to plus will delay your vw fault. |
19085 Possible Causes:
19085 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Cylinder 1 Injector Circuit Low
- Fuel Rail/System Pressure - Too High
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 19085 Code
- Inspect all the connections exhaust gas temperature sensor, bank 1 sensor 5, circuit intermittent / erratic
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns