VW Code 19059
19059 Description And Summary : |
---|
Accumulated in electronic control units so pressure control solenoid 5 (n233), electrical malfunction run rough, or might suddenly stall at any given speed a camshaft position actuator control bank 1, circuit low also hydraulic actuator position sender (g302), electrical malfunction in circuit is the final reason of the code. |
19059 Possible Causes:
19059 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 19059 Code
- Inspect all the connections bank 1; system too lean at idle
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns