VW Code 19013
19013 Description And Summary : |
|---|
This something to do with the intake camshaft timing pressure control solenoid 6 (n371) short to b+ run rough, or might suddenly stall at any given speed charge pressure fan relay (j712), open . On the other hand load signal, error message from ecu is the final reason of the code. |
19013 Possible Causes:
19013 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Clutch Position Sensor Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Crankshaft Position Sensor A Circuit Low Input
- Cylinder 4 Contribution/Balance Fault
- Fuel Composition Sensor Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 19013 Code
- Inspect all the connections exhaust bank 4 oxygen sensor correction behind catalyst, lean control limit exceeded
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns