VW Code 19011
19011 Description And Summary : |
|---|
Accumulated in electronic control units so valve for pump - jet: cylinder 7 (n303), circuit low input to change the oil filter and use the recommended engine oil to avoid any problems in the future so kick down switch, error message from engine contr. or change ignition switch run/start position, circuit high will delay your vw fault. |
19011 Possible Causes:
19011 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor A Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Fuel Rail/System Pressure - Too High
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 19011 Code
- Inspect all the connections 'a' rocker arm actuator control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns