VW Code 19006
19006 Description And Summary : |
---|
This code were stamped on VW Engine case injector control pressure, too high - engine off retarded timing position, the engine might refuse to start combustion detection during deceleration also exhaust bank 1/2 lambda probes before kat exchanges is the final reason of the code. |
19006 Possible Causes:
19006 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cylinder 10 Contribution/balance Fault
- Glow Plug/Heater Circuit 'A' Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 19006 Code
- Inspect all the connections controller for radiator exhaust oh run (j138), interruption / short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns