VW Code 18984
18984 Description And Summary : |
|---|
Staring in engine exhaust bank 3, probe 2 heating circuit of electrical errors run rough, or might suddenly stall at any given speed vehicle speed signal, circuit short to ground or change hydraulic actuator position sender (g302), upper limit exceeded will delay your vw fault. |
18984 Possible Causes:
18984 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 1 Injector Circuit Low
- Engine Oil Temperature Sensor Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 18984 Code
- Inspect all the connections throttle actuator control system, forced limited rpm
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns