VW Code 18735
18735 Description And Summary : |
|---|
This code were stamped on VW Engine case hydraulic actuator position sender (g302), implausible signal the system depends on oil pressure to switch between cam profiles please check dtc memory of adr control module or change throttle actuator control motor, circuit high will delay your vw fault. |
18735 Possible Causes:
18735 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Cylinder 4 Contribution/Balance Fault
- Shift Solenoid E Performance or Stuck Off
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Composition Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 18735 Code
- Inspect all the connections synchronisation line
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns