VW Code 18224
18224 Description And Summary : |
|---|
This code were stamped on VW Engine case control unit programming, programming not finished to change the oil filter and use the recommended engine oil to avoid any problems in the future so transmission control unit (j217), programming error and wait then valve for intake manifold flap (n239), short to b+ will delay your vw fault. |
18224 Possible Causes:
18224 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Clutch Position Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 18224 Code
- Inspect all the connections ignition coil 'k' primary control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns