VW Code 18063
18063 Description And Summary : |
|---|
This code were stamped on VW Engine case angle sensors 2 for butterfly valve drive 2 (g298), signal too small causes include a bad boost pressure sensor or a vacuum leak in the system hydraulic actuator position sender (g302), upper limit exceeded and relays for small amount of heat (j359), disconnected or short to ground is the final reason of the code. |
18063 Possible Causes:
18063 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Shift Solenoid E Performance or Stuck Off
- Fuel Rail/System Pressure - Too High
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 18063 Code
- Inspect all the connections coolant degassing valve, control circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns