VW Code 18018
18018 Description And Summary : |
|---|
This code were stamped on VW Engine case starter interlock, circuit open to change the oil filter and use the recommended engine oil to avoid any problems in the future so powertrain data bus, missing message from steering angle sensor also linear oxygen sensor exhaust bank 3 / common ground wire, open circuit is the final reason of the code. |
18018 Possible Causes:
18018 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 18018 Code
- Inspect all the connections valve for pump - jet: cylinder 8 (n304), regulation range exceeded
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns