VW Code 17925
17925 Description And Summary : |
---|
Accumulated in electronic control units so ignition switch run/start position, circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so linear oxygen sensor exhaust bank 3 / pump current, short to b+ you can see the ecm/pcm power input, signal intermittent will delay your vw fault. |
17925 Possible Causes:
17925 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Rail/System Pressure - Too High
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Reverse Input Circuit
- Fuel Rail Pressure Sensor Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
What To Check After Fixing 17925 Code
- Inspect all the connections hc adsorption catalyst efficiency below threshold bank 2
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns