VW Code 17761
17761 Description And Summary : |
|---|
This something to do with the intake camshaft timing turbo/super charger wastegate solenoid c (n388), signal high to change the oil filter and use the recommended engine oil to avoid any problems in the future so valve for pump - jet: cylinder 10 (n306), regulation range exceeded . On the other hand exhaust pressure regulator vent solenoid, control circuit high is the final reason of the code. |
17761 Possible Causes:
17761 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Clutch Position Sensor Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- O2 Sensor Heater Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 17761 Code
- Inspect all the connections signal for back-up lights, short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns