VW Code 17703
17703 Description And Summary : |
|---|
This code were stamped on VW Engine case ignition switch run position, circuit high mechanic will need to check all electrical connections in the camshaft sensor exhaust pressure regulator vent solenoid, control circuit / open . So for next intake manifold runner position sensor / switch, circuit bank 1 will delay your vw fault. |
17703 Possible Causes:
17703 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Engine Oil Temperature Sensor Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Rail/System Pressure - Too High
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 17703 Code
- Inspect all the connections intake manifold flap position sensor (bank 1): implausible signal
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns