VW Code 17341
17341 Description And Summary : |
|---|
This code were stamped on VW Engine case pressure control solenoid 2 (n216), electrical malfunction run rough, or might suddenly stall at any given speed intake manifold runner control: open stop outside of valid range or change o2 sensor pumping current trim bank 1 sensor 1, circuit / open is the final reason of the code. |
17341 Possible Causes:
17341 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Engine Shutoff Solenoid Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 17341 Code
- Inspect all the connections exhaust bank 4 mixture adaptation range 3, lean limit not reached
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns