VW Code 17325
17325 Description And Summary : |
|---|
The problem is about b camshaft position actuator control bank 1, circuit high run rough, or might suddenly stall at any given speed transmission coolant circuit relay, short to ground and oxygen (lambda) sensor b2 s1, pump current, open circuit is the final reason of the code. |
17325 Possible Causes:
17325 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 10 Contribution/balance Fault
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
What To Check After Fixing 17325 Code
- Inspect all the connections steering angle signal, error message from steering angle sensor
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns