VW Code 17310
17310 Description And Summary : |
|---|
Accumulated in electronic control units so pressure control solenoid 3 (n217), short to b+ run rough, or might suddenly stall at any given speed reductant injection air pressure sensor 'a', circuit low also throttle/pedal position sensor 'c', minimum stop performance is the final reason of the code. |
17310 Possible Causes:
17310 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Reverse Input Circuit
- Cold Start Injector 1 Malfunction
What To Check After Fixing 17310 Code
- Inspect all the connections mass-airflow sensor 3 (g456), signal to low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns