VW Code 17309
17309 Description And Summary : |
|---|
The problem is about b camshaft position actuator control bank 2, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so engine coolant temperature signal, open / short to b+ or change idle regulation lean operation: rpm too high will delay your vw fault. |
17309 Possible Causes:
17309 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Reverse Input Circuit
- Exhaust Gas Recirculation Sensor B Circuit High
- Ambient Air Temperature Sensor Circuit Low
- Cylinder 1 Injector Circuit Low
- Crankshaft Position Sensor A Circuit Low Input
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 17309 Code
- Inspect all the connections o2 sensor pumping current trim bank 1 sensor 1, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns